Garrido Electronics
Blog
Practical notes from the bench on hardware, PCB layout, firmware, prototyping and getting a product into production.
Medical device classes: how the MDR classifies a device
Classes I, IIa, IIb and III: what the class decides, which Annex VIII rules apply to electronic equipment and why the FDA class does not translate.
Hardware debugging: from first board to intermittent faults
How to power up a new board without damaging it, measure without the probe fooling you and corner a fault that only shows up now and then.
The phases of electronic product development
From idea to manufacturing: what each phase delivers and decides, and how to move through them with Stage-Gate, the V-model or an iterative approach.
What certification does an electronic device need in the EU?
There is no single EU certification, but CE marking. Which legislation applies depending on what your product contains, and when you need a notified body.
What is a medical device? MDR and FDA for manufacturers
It is not the hardware that decides, but what you say it does. How the MDR and FDA define a medical device and what changes in the electronics if yours is one.
PHP2Shell and the CRA: what to do if your product runs PHP
Two critical PHP vulnerabilities are being exploited. How to tell if your product is affected, what to do now and when the CRA requires you to report it.
Cyber Resilience Act (CRA): guide for manufacturers
What the Cyber Resilience Act is, who it affects, which dates matter and what a manufacturer of electronic products has to do to comply.
Seven checks before you order your first PCB batch
A practical checklist to run before sending a board to manufacturing, so the first batch is a working prototype and not an expensive lesson.